AirLive(歐立科技) is a well-known IP Surveillance Networking solutions which provide solutions both surveillance and network solution. WL-5460AP v2, EU. 4 INTRODUCTION AirLive WL-5450AP/WL-5460AP is an IEEE802.11b/g compliant 11 Mbps & 54 Mbps Ethernet Wireless Access Point. The Wireless Access Point is equipped with. AirLive(歐立科技) is a well-known IP Surveillance Networking solutions which provide solutions both surveillance and network solution, products includes: Fiber. Download drivers for AirLive WL-5460AP v2. Drivers are compatible with operating systems.

I have a modem of my ISP installed at home. I want to connect my WL-5460AP v2 to it, so need to connect one of the two Ethernet ports of the back of the WL-5460AP to the modem exit (Ethernet port). Only 1 IP address comes out of the modem, so I have a modem of my ISP installed at home. I want to connect my WL-5460AP v2 to it, so need to connect one of the two Ethernet ports of the back of the WL-5460AP to the modem exit (Ethernet port). Only 1 IP address comes out of the modem, so the WL-5460AP needs to behave as router as well. Can it be done and if so, which settings do I need to select to:(1) Use it as a router (providing IP addresses to the multiple PC’s that want to connect to the WL-5460AP(2) Can I still also use the second Ethernet port to connect a wired PC to the WL-5460AP?

Please check if your WL-5460AP's serial number is e5460AP70500001 or later. If it is, it has emergency code function. Otherwise, it doesn't. Download Sparks The Heaven Collection Rar.

Once you make sure it has emergency code function. Please follow the steps below: • Unplug the power of WL-5460AP. • Hold the reset button while plugging the power. Do not release the reset button until the 'Status' LED goes off. • Set your PC's IP address to 192.168.1.199. Connect your PC to the WL-5460AP.

• Open your web browser, then type '192.168.1.6'. You should see the emergency code page where you can upload your AirLive firmware again. The watchdog functions works by using the PING command. When activated, the AP will ping the 'Watch Host' continuously. If no PING response after a period of time (the Watch Interval), then the AP will reboot itself. • Please open the Web UI and go to 'Wireless->Advance Settings'. • Check the 'Enable Watchdog' box • 'Watch Interval' is the time the AP will wait for a PING respond before it reboot the router.

For example, if you put one minute for watch Interval. After the PING is lost for one minute, the AP will reboot itself. • 'Watch Host' is the IP address for which the AP will ping for the watchdog function. This can be a remote AP, or a local client. Wayteq Xpad-70 Games Programs. Please remember that the 'Watch Host' IP address must be in the same IP subnet as the AP. If the IP address is on Internet, you must configure the Gateway information correctly.